This is an old revision of the document!
Work in progress
Disclaimer: what follows is true for LIME and LIME2 hardware.
Installing the system on a SATA drive is not straightforward, mainly for one reason : the LIME(2) cannot boot from the SATA port. To make it work, you need to leave a minimal system on the SD card (the /boot folder) so the bootloader can find a kernel to boot, then the kernel will seek the rest of the system on the SATA drive.
Let's start with a working cube, with the system running from the SD card and a SATA drive plugged. You are logged in as root on your cube.
Partitionning and formatting
First, you have to prepare the drive. You will need at least one partition for the system (the root or / partition), and possibly others for folders containing user data, such as /home and /var. Let's keep it simple for now, with everything (except /boot of course) on the same partition.
to create a partition on your disk, run cfdisk /dev/sda. The tool should be self explanatory - you should remove any existing partition, then create a primary partition with the number 1. When asking for the start and end of the partition, just use the default values and the partition will fill the whole disk.
Now, you should have a file called /dev/sda1
To format your new partition, just run mkfs.ext4 /dev/sda1
Changing the boot configuration
When booting, your cube needs to know where to find the root partition. To do so, edit the file /etc/default/flash-kernel
in this file, replace root=/dev/mmcblk0p1 (“the root partition is on the SD card”) with root=/dev/sda1 (“the root partition is on the drive”).
Now, run flash-kernel. This will regenerate the /boot/boot.scr file. You may open this file and check if the line root=/dev/sda1 is in there.
You will also need to modify /etc/fstab to match the desired configuration:
/dev/mmcblk0p1 /boot ext4 defaults 0 1 # /boot on the SD card /dev/sda1 / ext4 defaults 0 1 # root on SATA drive